Ultra Flex
Get a quote

Ultra Seal Water Proofing

Home Ultra Seal 550 SL

Ultra Seal Water Proofing

UltraSeal 550 SL is a two part,prepacked system,consisting of a liquid polymer as Part A and a premixed powder as Part B. The two parts on mixing yield a powder as Part B. The two parts on mixing yield asubstrates. The product is based on selected synthetic resins and cements.

The foolproof solution to water leaks

Features
  • It can be used both indoors and outdoors. No additional polymers are required. Simply add water.
  • The easy workability of the product and non-sticky allow better levelling, hence giving the perfect finish.
  • Absorption of paint is minimal, resulting in less paint consumption. Resistant to shrinkage.

Application Instructions

SUBSTRATE PREPARATION
Absorbent surfaces have to be thoroughly saturated with water prior to application of first coat of ultrSeal 550 SL. However, no loose standing water should be on the surface before application.
SUBSTRATE QUALITY / PRE-TREATMENT
Concrete, mortar and masonry surfaces must be clean, free from grease, oil and loosely adhering particles. Steel and iron surfaces must be clean, free from scale, rust, grease and oil. All surfaces must be as true and flat as possible.
MIXING
Under normal circumstances, when the full quantities of both parts are mixed together, a creamy consistency will result. Mix in a clean container by slowly adding the powder part to the liquid part and stirring with a paddle attached to a slow speed mixer (400 - 500 rpm).
APPLICATION
Whilst the substrate is still damp but free from standing water, apply the first coat by brush, broom, roller or squeegee (if the surface is flat enough), working the material well into the substrate to achieve full bond. Allow 4-8 hours (+20 °C) for the first coat to cure before applying the following coats in the same manner. For large areas, ultraSeal 550 LK can be applied by spray using a suitable worm type mixer/pump. An additional stripe coat is recommended over cracks, wall/floor intersections, etc. as these locations are where movement is most likely to be expected in service.
Consumption
For bathroom floors, shower area floors and wet kitchen floors, minimum 2 coats at approximately 1.0 kg/m2 per coat. Splash zone area of wall with tiles, . bathroom wall, shower area wall and wet kitchen wall, 1 coat at approximately 1.0-1.5 kg/m 2 per coat. All other areas, minimum 2 coats at approximately 1.0 kg/m2 per coat. For areas subject to high water ingress, apply a third coat at 1.0 kg/m2
Pot Life
30 minutes (at +20 °C) Pot life is shorter at higher temperatures. Cover material container when not in use.

Coverage Area

Generally covers 10-15 sq.ft / 01 kg.